3:1 Adhesive Lined Polyolefin

Our 3:1 heat shrink tubing with a "dual-wall" construction. When exposed to heat (usually a bit lower than the activation temperature of the heat shrink), the inner layer begins to flow (just like a hot melt glue). When the tubing shrinks and cools down, inner layer forms an adhesion layer between the tubing and the component or wire. This provides a water-tight seal, protecting the connector and/or wire. Features: 3:1 Shrink Ratio with melt adhesive inner lining (shrinks to 1/3 its original diameter) Up to 15% longitudinal shrinkage Meets requirements of AMS-DTL-23053/4 (formerly MIL-I-23053/4), Class 3 UL 224 VW-1 and CSA OFT recognized Maximum use temperature 135°C Shrink Temperature of 90°C and operating temperature of -55°C to + 110°C Crosses to : Sumitomo W3B2, Raychem ATUM, Alpha FIT-321, 3M EPS-300, Canusa CPA-100 , LG GSHS-3635W Typical applications include: Insulation, Wire Identification, Wire Bundling, Mechanical Protection, Color Coding, Lightweight Harnessing, Physical/Electrical Protection of Components, Strain Relief, and Solder Insulation.